Shrink disc steel 23382-62110
- To connect a hollow shaft to a shaft
- Suitable for static, dynamic and shock loads
- For very high torques
- No shift of axial shaft/hub during assembly
- Self-centring
Unità di vendita
€51.89
Aggiunto al carrello
Denominazione
Anello calettatore
Forma
B
Materiale
Corpo base
acciaio
D1=Diametro esterno
110
D=Diametro interno
62
B
34,5
Codice UNSPSC
23153102
Coppia di serraggio
delle viti di serraggio
MS Nm
35
Coppia trasmissibile
M Nm alla
coppia di serraggio MS
2200/2500/2700
DW
48/50/52
Forza assiale trasmissibile
F kN alla
coppia di serraggio MS
92/98/105
L
29
L1
24,5
Numero
di viti di serraggio
9 x M8
Pressione superficiale
sul mozzo P
N/mm²
318
~ CONFLICT MINERALS 3TG status
no intentional 3TG
~ CP65 substance 2 cancer
soots, tars, and mineral oils
~ PFAS free?
yes
~ REACH SVHC-free?
yes
~ RoHS conformity
yes, without exemption
~ TSCA 6(H) conformity
yes
Descrizione
Material
Steel.
Version
Bright.
Note
Shrink disc to connect a hollow hub to a shaft. They are mounted on the OD of the hub and generate pressure on the hub wall by reducing the ID with wedge-formed rings, creating a press fit between the hub and shaft. They are suitable for static, dynamic and shock loads.
- for extremely high torques
- no axial shaft/hub offset when assembling
- self-centring
The version 23380-01-4072 has high tensile ISO 4762 screws.
- for extremely high torques
- no axial shaft/hub offset when assembling
- self-centring
The version 23380-01-4072 has high tensile ISO 4762 screws.
Assembly
Remove existing transportation locks. Clean and lightly oil shaft, internal and external hub diameters. Do not use MoS2 or grease. Slide shrink disc onto hub. Then slide unit (shrink disc/hub) onto shaft and position correctly. Gently tighten clamping screws one after the other by hand. Then use a torque wrench to tighten the clamping screws crosswise in several increments to the defined tightening torque MS.
1st increment approx. 33% MS
2nd increment approx. 66% MS
3rd increment 100% MS
Dismantling: Gradually loosen all screws one after the other but do not fully remove from the thread. The shrinking disc usually loosens itself.
1st increment approx. 33% MS
2nd increment approx. 66% MS
3rd increment 100% MS
Dismantling: Gradually loosen all screws one after the other but do not fully remove from the thread. The shrinking disc usually loosens itself.
Nota importante sul download dei modelli CAD
Per poter scaricare i nostri modelli CAD, occorre effettuare il login. Se non è stato ancora creato un account, si prega di registrarsi alla voce "Il mio account" (lato destro dello schermo) e di seguire le istruzioni.
Altri clienti hanno acquistato anche
