Through the interaction of zero-point mounting and pin, SOLIDBolt can be used to equip large machine tables for a fraction of the original cost. In detail, this means that machine tables or baseplates are equipped with zero-point bolts and not with zero-point mechanics across the board. The zero point technology is only used selectively at the required points. This saves money, especially for tables with more than one multi-clamping point.

Steel.

Ground

PRODUCT NOTE FOR LATHE OPERATIONS:
Max. 800 rpm, under the following conditions:
- All pins on each riser must always be used.
- Machining radius / clamping device radius max. 120 % of the outer zero point bolt radius.
- 1x riser or at least 3x risers must be used.
- Symmetrical circular pattern in the arrangement of risers is mandatory.
- If the clamping device used on SOLIDBolt MAXX allows for a speed of less than 800 rpm, the speed specified by the clamping device is used as the maximum speed.

The following items are excluded from a speed of 800 rpm:
- 42836-12596100, 42836-12596150
These two zero point plates only have a max. speed of 400 rpm.

Form A: including 8 locating pins.
Form B: including 8 locating pins.
Form C: including 4 locating pins.

Form A Hole pattern: individual
Form B Hole pattern: individual
Form C Hole pattern: individual

42837 Zero point bolt.